Generator; Generator Pulley; How To Remove The Generator Pulley; How To Install The Generator Pulley - Genie Z-45 Service And Repair Manual

September 2016
7-1

Generator Pulley

How to R emove the Generator Pulley
How to Remove the Generator
Pulley
1 Remove the engine pivot plate latch retainer.
2 Open the engine pivot plate latch and swing
the engine out away from the machine to
access the generator pulley.
3 Loosen the tension adjustment bolt on the

generator.

4 Pull the generator away from the machine and
remove the belts from the generator pulley.
5 Disconnect the battery cables from the engine
battery.
Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
6 Remove the engine battery hold down, then
remove the battery from the machine.
7 Remove the generator pulley retaining nut
from the generator shaft.
8 Slide the pulley off of the generator shaft.
Part No. 1268546GT Z®-45/25 Bi-Energy • Z®-45/25J Bi-Energy
How to Ins tall the Generator Pull ey
How to Install the Generator
Pulley
Note: The pulley on the generator must be installed
before installing the engine drive pulley.
1 Align the woodruff key on the generator shaft
with the slot in the pulley and slide the pulley
all the way onto the generator shaft.
2 Install the flat washer and pulley retaining nut
onto the generator shaft, then torque the nut to
specification. Refer to Specifications,
Generator.
3 Adjust the tension of the generator belts. Refer
to Repair Procedure, How to Adjust the
Generator Belts.
Service and Repair Manual
Generator
43