First Use Each Day (Tank And Boiler Empty); Choosing The Program - Smeg UD505DSUK User Manual

8.3 First use each day (tank and boiler empty)

When the door is closed again, the system offers the last program run.

8.4 Choosing the program

SYMBOL
(*) The cycle duration stated above is guaranteed if the appliance is connected to hot water > 50°C <60°C
If the dishwasher is supplied with cold water, the cycle duration might increase depending on the intake water temperature
and the "Thermostop" setting.
PROGRAM
Short
Medium
Long
Door closed and master switch on ON:
Press and hold for 2/3 seconds, Leds ON/OF light up and
the firmware version and e revision are displayed (F xxx r xxx...);
FILL is displayed afterwards.
Tank filling starts. When the tank is full the display reads "End"
alternating with the last running program (End/P1).
Load the dishes and close the door
Select the program required by holding down one of the three
buttons required for about 2"; the Led of the program flashes.
During the wash, a series of vertical bars on display indicate the
progress of the selected program.
When the program is over, the program led stops flashing and
stays on, the display alternates the run program and "End" (ex.
P2/End).
Unload the dishes
TYPE OF DIRT
Glasses and cups
Glasses, cups and plates with light dirt
Very dirty dishes and cutlery
17
DURATION (*)
1'30"
2'30"
4'