Smeg UD505DSUK User Manual page 26

INSUFFICIENT RINSE
INSUFFICIENT DRYING
STAINED GLASSES AND CUTLERY
WATER LEFT IN THE TANK AFTER
PUMP-OUT.
Badly positioned dishes / glasses.
Low washing temperature
Improper set cycle
Clogged nozzles
Boiler incrusted with limescale
Inappropriate rinse aid, or it is not
dispensed correctly.
Low rinsing temperature
Inappropriate rinse aid, or it is not
dispensed correctly.
Water hardness superior than 12°dF
or it contains many dissolved salts.
Waste tube badly positioned or
partially clogged.
Waste tube badly positioned or
partially clogged.
24
Place dishes / glasses correctly.
Verify the temperature displayed,
if it is inferior than 50°C contact
customer Support.
Increase the duration of the washing
cycle, especially if the load is very dirty or
partially dried.
- Verify that the nozzles are clean and that
the water softener, if present, is working
correctly.
- Verify that the filter of the tube placed
inside the rinse aid jerrycan is not
clogged.
Verify the rinse aid container and if it is
adequate to the type of mains water.
Verify the boiler set temperature
Restore T Stop ON and/or connect the
machine to hot water.
If the problem is not solved, contact the
After-Sales Service.
Verify the rinse aid container and if it is
adequate to the type of mains water. If
the problem is not solved, contact the
After-Sales Service
Verify that the tube and drainage are not
clogged and that the drainage is not
positioned too high; see connection
scheme.
Verify that the tube and drainage are not
clogged and that the drainage is not
positioned too high; see connection
scheme.