Table of Contents
Advertisement
9.2 First use each day (tank and boiler empty)
With the door/hood closed:
Press
and hold it down.
The display shows the firmware version and update
installed, then the tank and boiler temperatures.
This is followed by FILL and the boiler water
temperature.
The boiler heating element symbol
remains lit until
heating finishes. Once the water in the boiler has been
heated, filling of the tank starts.
Wait for P1 - END to appear and light L2 to change from
blue to green; if the water in the tank has to be heated,
comes on until the set temperature is reached. The
duration of this stage may vary depending on the mains
water temperature and on the single-phase connection
(if possible, depending on the model).
Press the
button quickly to display the tank (left)
and boiler (right) temperatures for a short time.
Load the dishes
Close the door and the cycle starts
1- Select the program required by pressing
.
Only with Autostart OFF:
2- Confirm the program start by pressing
and
holding it down for 1 second (light L2 changes from
green to blue).
25
Advertisement
Table of Contents
