Before Washing - Smeg UD505DSUK User Manual

Using the buttons
Button
Display of temperatures in
Boiler (L3) and tank (L1)
Set P0

8.2 Before washing

Use only detergents and rinse aids for industrial dishwashers. Do not use detergents intended for hand washing.
We recommend the use of Smeg products, specially developed for this dishwasher.
When topping up the tanks, take care not to swap the products; this might damage the dishwasher and cause
malfunctions.
Do not mix different detergents; this would damage the dispenser device. Failure to comply with this recommendation
leads to forfeiture of the warranty entitlement on the appliance's water system.
Industrial dishwasher detergents may cause serious irritation. Comply carefully with the instructions provided by the
detergent producer on the pack.
Check
1. Turn on the mains
water tap (user)
Short press
On/OF
Start Short Programme
Start Medium
Programme
Start Long Programme
2. The level of detergent
and rinse aid in the
containers.
Pressed for 2"
Start total drain (tank + boiler)
Start programme P0: emptying of tank to clean filters.
Switch off and back on to allow reuse.
3. That there is
regenerating salt in
the relative
container (if fitted).
16
Pressed for 5"
4. That the filters are
in place, the spray master switch (user):
arms rotate, and the decimal points of
there are no foreign both digits appear on
bodies in the
dishwasher.
5. Switch on the
the display.