Table of Contents
Advertisement
9.2 First use each day (tank and boiler empty)
Door closed and master switch on ON:
Press
and hold for 2/3 seconds, Leds ON/OF light
up and the firmware version and e revision are
displayed (F xxx r xxx...); FILL is displayed afterwards.
Tank filling starts. When the tank is full the display reads
"End" alternating with the last running program
(End/P1).
Load the dishes
Close the door and the cycle starts
Select the program required by holding down one of the
three buttons required for about 2"; the Led of the
program flashes.
During the wash, a series of vertical bars on display
indicate the progress of the selected program.
When the program is over, the program led stops
flashing and stays on, the display alternates the run
program and "End" (ex. P2/End).
Unload the dishes.
When the dishwasher is closed again, the system offers
the last program run.
24
Advertisement
Table of Contents
