Electrical Connection - Smeg UD505DSUK User Manual

4.2 Electrical connection

The dishwasher and any additional equipment must be connected to the electrical system by authorised,
skilled staff, in accordance with the relevant regulations; also comply with the technical instructions for the
connection. The total rated power is stated on the appliance's technical data plate. The electrical protection
devices fitted for the dishwasher must serve this appliance only. The user must have a master switch and a
differential safety breaker, with rating suitable for the appliance's characteristics, installed on the
electricity supply line in accordance with the relevant regulations. These switches must be installed close
to the dishwasher, be easily accessible after installation, and provide complete disconnection from the
electrical mains in overvoltage class III conditions.
Warning!
The dishwasher is always powered up unless the master switch is turned off.
Connect the appliance to the user's earth system. The terminal for the connection is in the bottom right-
hand corner of the appliance. The earth wire (PE) is yellow-green in colour, the neutral wire (N) is blue and
the live wires (L1, L2, L3) are black, grey and brown. In the event of single-phase connection (230V-1N~), the
connection to the electrical mains must be made using a cable with plug compliant with the relevant
regulations.
According to the target market, the dishwasher can be equipped with a cable fitted with plug.
THE POWER SUPPLY CABLE, IF FITTED, MUST BE REPLACED BY THE MANUFACTURER OR AN AUTHORISED
SERVICE CENTRE IN ACCORDANCE WITH THE TECHNICAL DATA SPECIFIED ON THE WIRING DIAGRAM
SUPPLIED WITH THE APPLIANCE, TO PREVENT ALL RISKS.
7