First Use Each Day (Tank And Boiler Empty) - Smeg UG411DSUK Manual

9.2 First use each day (tank and boiler empty)

With the door/hood closed:
Press and hold it down.
The display shows the firmware version and update
installed, then the tank and boiler temperatures.
This is followed by FILL and the boiler water temperature.
The boiler heating element symbol remains lit until
heating finishes. Once the water in the boiler has been
heated, filling of the tank starts.
Wait for P1 - END to appear and light L2 to change from blue
to green; if the water in the tank has to be heated,
comes on until the set temperature is reached. The duration
of this stage may vary depending on the mains water
temperature and on the single-phase connection (if possible,
depending on the model).
Press the button quickly to display the tank (left) and
boiler (right) temperatures for a short time.
Load the dishes
Close the door/lower the hood and the cycle starts
1- Select the program required by pressing .
Only with Autostart OFF:
2- Confirm the program start by pressing and holding it
down for 1 second (light L2 changes from green to blue).
Cycle in progress, the progress of the cycle is displayed by
vertical bars which illuminate in sequence.
At the end of the program "END" flashes
Unload the dishes.
When the dishwasher is closed again, the system offers the
last program run.
23