First Use Each Day (Tank And Boiler Empty) - Smeg UD515D Translation Of The Original Instructions

9.2 First use each day (tank and boiler empty)

Load the dishes
Close the door and the cycle starts
With the door/hood closed:
Press and hold it down.
The display shows the firmware version and update
installed, then the tank and boiler temperatures.
This is followed by FILL and the boiler water temperature.
The boiler heating element symbol
heating finishes. Once the water in the boiler has been
heated, filling of the tank starts.
Wait for P1 - END to appear and light L2 to change from blue
to green; if the water in the tank has to be heated,
comes on until the set temperature is reached. The duration
of this stage may vary depending on the mains water
temperature and on the single-phase connection (if possible,
depending on the model).
Press the button quickly to display the tank (left) and
boiler (right) temperatures for a short time.
1- Select the program required by pressing
Only with Autostart OFF:
2- Confirm the program start by pressing
down for 1 second (light L2 changes from green to blue).
Cycle in progress, the progress of the cycle is displayed by
vertical bars which illuminate in sequence.
28
remains lit until
.
and holding it