Set Lec (Server-Addr) - Avaya Cajun P550R Cli Reference Manual

Chapter 1

set lec (server-addr)

Command Mode
Description
Syntax
Sample Output
1-44
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
Configuration
Set the server ATM Address used by the LEC to connect to the
ELAN.
* Note: You must disable a LEC each time you make a change to
the configuration. After you make configuration
changes, you must enable the LEC in order for the
changes to take effect.
set lec <lecID> server-addr
{<atm-address> | default>}
Table 1-35. Parameters, Keywords, Arguments
Name
lecID
atm-address | default
This example sets the server ATM address for LEC 2 to default.
ATM(configure)# set lec 2 disable
LEC 2 has been disabled
ATM(configure)# set lec 2 server-addr default
Server ATM Address DEFAULT has been set for
LEC 2
ATM(configure)# set lec 2 enable
LEC 2 has been enabled
Definition
The LEC identifier. The range of values is:
Minimum = 1, Maximum = 128.
The server ATM address. Options are the
20 byte ATM address of the server or the
default well-known address.