Set Lec (Max-Count) - Avaya Cajun P550R Cli Reference Manual

Chapter 1

set lec (max-count)

Command Mode
Description
Syntax
Sample Output
1-38
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
Configuration
Set the maximum unknown frame count per time interval for a
LEC. This parameter determine how many frames will be sent using
the BUS or a lower priority VC before a Data Direct VC will be
created for traffic at this priority level. This works in conjunction
with the max-time parameter.
* Note: You must disable a LEC each time you make a change to
the configuration. After you make configuration
changes, you must enable the LEC in order for the
changes to take effect.
set lec <lecID> max-count <max-count-value>
Table 1-29. Parameters, Keywords, Arguments
Name
lecID
max-count-value
This example sets the maximum unknown frame count for LEC 2 to
15 for a programmed time interval.
ATM(configure)# set lec 2 disable
LEC 2 has been disabled
ATM(configure)# set lec 2 max-count 15
Maximum Unknown Frame Count 15 has been set
for LEC 2
ATM(configure)# set lec 2 enable
LEC 2 has been enabled
Definition
The LEC identifier. The range of values is:
Minimum = 1, Maximum = 128.
The maximum unknown frame count. The
range of values is: Minimum = 1, Maximum =
20. The default is 10.