Set Lec (Trigger-Count) - Avaya Cajun P550R Cli Reference Manual

set lec (trigger-count)

Command Mode
Description
Syntax
Sample Output
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
Configuration
Sets the maximum number of Frames per second that the ATM
Uplink module will send to the BUS for forwarding rather than
establish a data direct VCC to the LEC.
* Note: You must disable a LEC each time you make a change to
the configuration. After you make configuration
changes, you must enable the LEC in order for the
changes to take effect.
set lec <lecID> trigger-count
<trigger-count-value>
Table 1-36. Parameters, Keywords, Arguments
Name
lecID
trigger-count-value
This example sets the trigger count for LEC 2 to a programmed time
interval of 15.
ATM(configure)# set lec 2 disable
LEC 2 has been disabled
ATM(configure)# set lec 2 trigger-count 15
LE ARP Trigger Count 15 has been set for LEC 2
ATM(configure)# set lec 2 enable
LEC 2 has been enabled
Avaya ATM Uplink Module CLI Commands
Definition
The LEC identifier. The range of values is:
Minimum = 1, Maximum = 128.
The LE ARP trigger count measured in
seconds. The range of values is: Minimum = 1,
Maximum = 20.
1-45