Set Lec (Selector) - Avaya Cajun P550R Cli Reference Manual

set lec (selector)

Command Mode
Description
Syntax
Sample Output
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
Configuration
Set the client selector for the LEC. This value will become the
selector byte in the 20th position of the ATM address and will
differentiate this LEC from other LECs on the ATM Uplink module
from the perspective of the ATM network.
* Note: You must disable a LEC each time you make a change to
the configuration. After you make configuration
changes, you must enable the LEC in order for the
changes to take effect.
set lec <lecID> selector <atm-addr-selector>
Table 1-34. Parameters, Keywords, Arguments
Name
lecID
atm-addr-selector
This example sets the ATM address selector for LEC 2 to 1F.
ATM(configure)# set lec 2 disable
LEC 2 has been disabled
ATM(configure)# set lec 2 selector 1F
ATM Address Selector 1F has been set for LEC 2
ATM(configure)# set lec 2 enable
LEC 2 has been enabled
Avaya ATM Uplink Module CLI Commands
Definition
The LEC identifier. The range of values is:
Minimum = 1, Maximum = 128.
The client selector for LEC. The range of values
should be (in hex) range 0 - FF (255).
Note:
The LEC selector must be unique
among LECs.
1-43