Set Network Prefix - Avaya Cajun P550R Cli Reference Manual

set network prefix

Command Mode
Description
Syntax
Sample Output
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
Configuration
Set the ATM address prefix of an ATM network. The prefix is a 13
byte (26 hex digit) number.
Example Prefix: 39.01.02.03.04.05.06.07.08.09.10.11.12 (Note:
periods have been inserted for readability. Do not use periods when
entering the ATM Prefix.)
* Note: You must disable a network each time you make a
change to the configuration. After you make
configuration changes, you must enable the network in
order for the changes to take effect.
set network prefix <atm-prefix>
Table 1-18. Parameters, Keywords, Arguments
Name
atm-prefix
This example sets the ATM address prefix.
ATM(configure)# set network disable
Network has been disabled
ATM(configure)# set network prefix
3900000000000000000000aa03
ATM Address Prefix set successfully
ATM(configure)# set network enable
Network has been enabled
Avaya ATM Uplink Module CLI Commands
Definition
Sets the prefix portion of the uplink's ATM
address.
Note:
The prefix must be a 13-byte number.
The first byte must be a valid Authority
and Format Identifier (AFIs 0x39, 0x47,
and 0x45) for Network Service Access
Point (NSAP) addressing as defined by
the UNI (User-to-Network Interface)
signaling specification.
1-23