Set Lec (Version) - Avaya Cajun P550R Cli Reference Manual

Chapter 1

set lec (version)

Command Mode
Description
Syntax
Sample Output
1-46
Avaya P550R/P580/P880/P882 Multiservice Switch ATM Uplink CLI Reference Guide, Version 2.0
Configuration
Set the LEC version.
* Note: You must disable a LEC each time you make a change to
the configuration. After you make configuration
changes, you must enable the LEC in order for the
changes to take effect.
set lec <lecID> version {v1 | v2}
Table 1-37. Parameters, Keywords, Arguments
Name
lecID
v1 | v2
This example sets LEC 2 to version V1.
ATM(configure)# set lec 2 disable
LEC 2 has been disabled
ATM(configure)# set lec 2 version v1
Version V1 has been set for LEC 2
ATM(configure)# set lec 2 enable
LEC 2 has been enabled
Definition
The LEC identifier. The range of values is:
Minimum = 1, Maximum = 128.
Set the LEC version to v1 or v2.