Using Telnet To Manage The Switch - Avaya P580 User Manual

Connecting to the
Supervisors 10/
100Base-T port

Using Telnet to Manage the Switch

Document No. 650-100-700, Issue 1
You can now connect to the switch using the front-panel out-of-band
10Base-T connection. This allows you to log in using either the embedded
Web Agent or the EMS.
See the Installation and Operation guides for instruction on establishing
additional IP network connections.
Connect one end of a crossover patch cable to the 10/100Base-T on the
Supervisor module front panel
of band device.
See Table 2-2 for an explanation of the pinouts for the 10Base-t crossover
patch cable.
Table 2-2. Pinouts for 10Base-T Crossover Patch Cables
Pin # Color
1 WO
2 O
3 WG
4 B
5 WB
6 G
7 WBr
8 Br
You can manage the Avaya Multiservice switch several ways. In addition to
managing the switch by means of the Web Agent, SNMP and serial console
command line interface (CLI) commands, the switch provides Telnet server
capability. Through this Telnet session, an administrator can manage the
switch by means of CLI commands.
As a more secure alternative to Telnet, you can use SSHv2. For information
on using an SSH connection to manage the switch, see "SSHv2" in
Chapter 4, "Security."
(Figure 2-1). Connect the other end to an out
Pin #
3
6
1
4
5
2
7
8
Setting Up the Switch
Color
WG
G
WO
B
WB
O
WBr
Br
2-5