Command And Response Table For Dsp Sis Commands - Extron electronics DMP 128 Plus User Manual

Command and Response Table for DSP SIS Commands

Command
Audio level control and mix-point selection
NOTE: The command format is the same, regardless of the control being set. The acceptable adjustment range
varies depending on the control or mix point.
• The mic/line input gain range is -18 dB to +80 dB in 0.1 dB increments.
• The pre-mixer and virtual return gain range is -100 dB to +12 dB in 0.1 dB increments.
• The post-mixer gain range is -12 dB to +12 dB in 0.1 dB increments. Post mixer trim cannot be muted.
• The output gain range is -100 dB to 0 dB in 0.1 dB increments.
• All responses are shown with the DMP 128 in Verbose mode 2 or 3.
Set trim or gain
Example 1
(mic/line input 1):
Example 2
(pre-mixer gain 1):
Read trim or gain
Example 1
(mic/line input 1) :
Example 2
(post-mixer gain 1) :
Audio Mute
Audio mute
Audio unmute
Mute status
Phantom Power
Enable phantom power
Disable phantom power
Phantom power status
NOTES:
X7@ = Target OID
X7# = Level value: mic/line gain,
pre-mixer gain, virtual
return gain, post-mixer
trim, and output volume.
X7$ = Mute/Phantom power
status
ASCII command
(host to device)
E X7@ X7# }
G * AU
E }
G40000*120 AU
E }
G40100*-8 AU
E X7@ }
G AU
E }
G40000AU
E }
G60100AU
E X7@ }
M *1AU
E X7@ }
M *0AU
E X7@ }
M AU
E X7@ }
Z *1AU
E X7@ }
Z *0 AU
E X7@ }
Z AU
Object ID (OID) Number Tables
See
Levels use a 10x multiplier system with no decimal spaces. For
example, a level of +10.4 dB would be entered as
of -3.2 dB would be entered as
= disabled
0
= enabled
1
Response
(device to host)
X7@ X7#]
DsG *
]
DsG40000*120
]
DsG40100*-8
X7@ X7#]
DsG *
]
DsG40000*550
]
DsG60100*55
X7@ ]
DsM *1
X7@ ]
DsM *0
X7@ X7$]
DsM *
X7@ ]
DsZ *1
X7@ ]
DsZ *0
X7@ X7$]
DsZ *
.
-32
DMP 128 Plus • Remote Control and Configuration
Additional description
X7@
Set gain on OID to a
X7#
value of dB.
Set the mic/line input 1 to
a level of +12.0 dB.
Set pre-mixer gain 1 to a
value of -0.8 dB.
X7@
Gain on OID is set to a
X7#
value of dB.
Mic/line input 1 gain is set
to a value of +55.0 dB.
Output 2, post mixer gain
is set to a value of +5.5 dB.
X7@
Mute audio at .
X7@
Unmute audio at .
Phantom power is only
available on mic/line inputs
1 through 8.
on page 150
and a level
104
143