Display Portal Acl - HP HSR6600 Command Reference Manual

Examples
# Configure the portal user detection function on interface GigabitEthernet 0/1, specifying the probe
packets as ARP requests, maximum number of probe attempts as 3, and probe interval as 10 seconds.
<Sysname> system-view
[Sysname] interface gigabitethernet0/1
[Sysname-GigabitEthernet0/1] access-user detect type arp retransmit 3 interval 10

display portal acl

Use display portal acl to display the ACLs on a specific interface.
Syntax
display portal acl { all | dynamic | static } interface interface-type interface-number [ | { begin | exclude
| include } regular-expression ]
Views
Any view
Default command level
1: Monitor level
Parameters
all: Displays all portal ACLs, including dynamic and static portal ACLs.
dynamic: Displays dynamic portal ACLs—ACLs generated dynamically after a user passes portal
authentication.
static: Displays static portal ACLs—ACLs generated through portal related configuration, such as
portal-free rule configuration.
interface interface-type interface-number: Displays the ACLs on the specified interface.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Examples
# Display all ACLs on interface GigabitEthernet 3/0/1.
<Sysname> display portal acl all interface gigabitethernet3/0/1
IPv4 portal ACL rules on GigabitEthernet3/0/1:
Rule 0
Inbound interface : GigabitEthernet3/0/1
Type
Action
Protocol
Source:
IP
Mask
: static
: permit
: 6
: 222.222.222.222
: 255.255.255.255
157