Nas Device-Id - HP HSR6600 Command Reference Manual

low-ip-address and high-ip-address: Start and end IP addresses of the address pool. Up to 1024
addresses are allowed for an address pool. If you do not specify the end IP address, there is only one IP
address in the pool, which is the start IP address.
Usage guidelines
You can also configure an address pool for PPP users in system view. An IP address pool configured in
system view is used to assign IP addresses to PPP users who do not need to be authenticated. To specify
the address pool used for assigning an IP address to the peer device, use the remote address command
in interface view.
An IP address pool configured in ISP domain view is used to assign IP addresses to the ISP domain's PPP
users who must be authenticated. Configure IP address pools for ISP domains in scenarios where an
interface serves a great amount of PPP users but the address resources are inadequate. For example, a
GigabitEthernet interface running PPPoE can accommodate up to 4096 users. However, only one
address pool with up to 1024 addresses can be configured on its VT. This is far from what is required. To
address the issue, configure address pools for ISP domains and assign addresses from them to the PPP
users by domain.
Examples
# Configure the IP address pool 0 with the address range of 129.102.0.1 to 129.102.0.10.
<Sysname> system-view
[Sysname] domain test
[Sysname-isp-test] ip pool 0 129.102.0.1 129.102.0.10
Related commands
ip pool (Layer 2—WAN Command Reference)
•
remote address (Layer 2—WAN Command Reference)
•

nas device-id

Use nas device-id to specify the device ID to be used in stateful failover mode. Two devices working in
stateful failover mode use the device IDs of 1 and 2.
Use undo nas device-id to restore the default.
Syntax
nas device-id device-id
undo nas device-id
Default
The router is operating in standalone mode and has no device ID.
Views
System view
Default command level
2: System level
Parameters
device-id: Device ID for the device, which can be 1 or 2.
37