Portal Auth-Network - HP HSR6600 Command Reference Manual

Field
Work-mode
VPN instance
MAC
IP
Vlan
Interface
Total 2 user(s) matched, 2 listed

portal auth-network

Use portal auth-network to configure a portal authentication source subnet on an interface. You can use
this command to configure multiple portal authentication source subnets on an interface. Then, only HTTP
packets from the subnets can trigger portal authentication on the interface. If an unauthenticated user is
not on any authentication source subnet, the access device discards all the user's HTTP packets that do
not match any portal-free rule.
Use undo portal auth-network to remove a specific portal authentication source subnet or all portal
authentication subnets.
Syntax
portal auth-network network-address { mask-length | mask }
undo portal auth-network { network-address | all }
Default
The portal authentication source subnet is 0.0.0.0/0, meaning that users in all subnets must pass portal
authentication.
Views
Interface view
Default command level
2: System level
Parameters
network-address: IP address of the authentication source subnet.
mask-length: Length of the subnet mask, in the range of 0 to 32.
mask: Subnet mask, in dotted decimal notation.
all: Specifies all authentication source subnets.
Usage guidelines
This command is only applicable for cross-subnet authentication (layer3). The portal authentication
source subnet for direct authentication (direct) can be any source IP address, and the portal
Description
User's working mode:
•
Primary.
•
Secondary.
•
Stand-alone.
MPLS L3VPN to which the portal server belongs.
MAC address of the portal user.
IP address of the portal user.
VLAN to which the portal user belongs.
Interface to which the portal user is attached.
Total number of portal users.
172