Platform Overload Indicator Light; Machine Not Level Indicator Light; Drive Enable Indicator Light; Drive Enable Switch - Genie Z-60/34 Operator's Manual

Seventh Edition · First Printing
12 Dual axis proportional control handle for drive
and steer functions
OR Proportional control handle for drive
function and thumb rocker for steer function
Move the control handle in the direction
indicated by the blue arrow on the control panel
and the machine will drive forward. Move the
control handle in the direction indicated by the
yellow arrow and the machine will drive
backwards. Move the control handle in the
direction indicated by the blue triangle and the
machine will steer to the left. Move the control
handle in the direction indicated by the yellow
triange and the machine will steer to the right.
OR
Move the control handle in the direction
indicated by the blue arrow on the control panel
and the machine will drive forward. Move the
control handle in the direction indicated by the
yellow arrow and the machine will drive
backwards. Press the left side of the thumb
rocker and the machine will steer to the left.
Press the right side of the thumb rocker and the
machine will steer to the right.

13 Platform overload indicator light

Light flashing indicates the platform is
overloaded and no functions will operate.
Remove weight until the light goes off.
14 Machine not level indicator light (if equipped)
The machine not level indicator light will come
on when the tilt alarm sounds.

15 Drive enable indicator light

Light on indicates that the boom has moved just
past either non-steer wheel and drive function
has been interrupted.
Part No. 133083

16 Drive enable switch

To drive when the drive enable light is on, hold
the drive enable switch to either side and slowly
move the drive control handle off center. Be
aware that the machine may move in the
opposite direction that the drive and steer
controls are moved.
17 Proportional control handle for secondary boom
up/down function
Move the control handle up
and the secondary boom
will raise. Move the control
handle down and the
secondary boom will lower.
18 Primary boom extend/retract switch
Move the primary boom
switch up and the primary
boom will retract. Move the
primary boom switch down
and the primary boom will
extend.
19 Used for optional equipment
20 Dual axis proportional control handle for primary
boom up/down and turntable rotate left/right
functions
Move the control handle up and
the primary boom will raise.
Move the control handle down
and the primary boom will
lower. Move the control handle
to the right and the turntable
will rotate to the right. Move the
control handle to the left and the
turntable will rotate to the left.
Z-60/34
Operator's Manual
Controls
21