Platform Overload System; How To Calibrate The Platform Overload System - Genie S-45 XC Service And Repair Manual

Service and Repair Manual
Platform Components
6 Move the function enable toggle switch to
either side and hold the platform rotate toggle
switch to the right position until the platform is
fully rotated to the right. Continue holding the
toggle switch until air stops coming out of the
bleed screw. Close the bleed screw.
Crushing hazard. Keep clear of
the platform during rotation.
7 Clean up any hydraulic oil that may have
spilled.
8 Rotate the platform fully in both directions and
inspect the bleed screws for leaks.
38 S-40 XC • S-45 XC • S-40 TraX • S-45 TraX
2-3

Platform Overload System

Proper calibration of the platform overload system
is essential to safe machine operation. Continued
use of an improperly calibrated platform overload
system could result in the system failing to sense
an overloaded platform.
How to C alibr ate the Pl atform Overl oad System
How to Calibrate the Platform
Overload System
Note: Perform this procedure with the machine on
a firm, level surface.
Note: The turntable level sensor must be calibrated
before performing this procedure.
1 Fully retract the boom. Level the platform.
2 Remove all material, tools and equipment
from the platform. Remove the welder (if
equipped).
Tip-over hazard. Failure to
remove all factory and
non-factory accessories could
result in the machine tipping
over, causing death or serious
injury.
3 Enter Service Mode. Refer to Repair
Procedure, How to Enter the Service Mode.
4 Press the settings button above the display
and select the Calibrations menu.
5 Navigate to the Sensor calibration screen.
6 Navigate to the Load Sense calibration
screen.
7 Select and start the calibration procedure.
8 Follow the on-screen instructions to set the
zero load.
9 Continue with the on screen prompts to set the
maximum load.
10 Place a 1,000 lb / 454 kg test weight on the
platform floor using a suitable lifting device.
Place the weight near the center entry point of
July 2019
Part No. 1286829GT