Test Drive And Braking; Test The Drive Enable System; Test Limited Drive Speed - Genie Z-60/34 Operator's Manual

Operator's Manual
Inspections

Test Drive and Braking

32 Press down the foot switch.
33 Slowly move the drive control handle in the
direction indicated by the blue arrow on the
control panel until the machine begins to move,
then return the handle to the center position.
Result: The machine should move in the
direction that the blue arrow points on the drive
chassis, then come to an abrupt stop.
34 Slowly move the drive control handle in the
direction indicated by the yellow arrow on the
control panel until the machine begins to move,
then return the handle to the center position.
Result: The machine should move in the
direction that the yellow arrow points on the
drive chassis, then come to an abrupt stop.
Note: The brakes must be able to hold the machine
on any slope it is able to climb.

Test the Drive Enable System

35 Press down the foot switch and lower the boom
to the stowed position.
36 Rotate the turntable until the primary boom
moves past one of the non-steer wheels.
Result: The drive enable
indicator light should come
on and remain on while the
boom is anywhere in the
range shown.
37 Move the drive control
handle off center.
Result: The drive function should not operate.
30
38 Move and hold the drive enable toggle switch to
either side and slowly move the drive control
handle off center.
Result: The drive function should operate.
Note: When the drive enable system is in use, the
machine may drive in the opposite direction that the
drive and steer control handle is moved.
Use the color-coded direction
arrows on the platform controls
and the drive chassis to
identify the direction of travel.

Test Limited Drive Speed

39 Press down the foot switch.
40 Raise the primary boom approximately 61 cm.
41 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the primary boom raised should not exceed
30 cm per second.
42 Lower the primary boom to the stowed position.
43 Extend the primary boom approximately 61 cm.
44 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the primary boom extended should not
exceed 30 cm per second.
Z-60/34
Seventh Edition · First Printing
Blue
Part No. 133083
Yellow