Packing List; Recommended Order Of Installation - FireplaceXtrordinair 42 Apex Clean Face Installation Manual

Packing List

NOTE: The log stop is secured for shipping with a set screw on the back of the log stop support. Loosen
the set screws with a 1/8" hex wrench and remove the log stop to access the internal
components.

Bricks (2 boxes – left side and right side)

Baffle

Air Intake Parts (10' of 3" diameter duct,
intake hood, hood bezel, and 2 hose clamps)

Ember strip

Switch Plate with Combustor Temp. Display
and Rheostat

Door Tool

Manifold / Non-Combustible Framing Parts

Face (ships pre-attached to the fireplace)

Recommended Order of Installation


Frame the opening for the fireplace. Leave the non-combustible framing and facing above the
fireplace open to allow for chimney installation.

Secure the fireplace to the framing/floor.

Install the chimney (and cooling air, if applicable), electrical, external wiring (rheostat, catalytic temp
reader, etc.), and outside air.

Install the Convection Air Manifold and non-combustible framing – see "Convection Air Manifold
Installation".

Install the ventilation grills used for chase ventilation

Install the hearth (if applicable)

Install the non-combustible facing.

Install the non-combustible mantel (if applicable).

Finalize the installation/
© Travis Industries
Installation
(for qualified installers only)
8/24/2017 - 1450

Owner's manual

Pair of gloves

Upper Manifold Trim

Front Ventilation Grill

Small Ventilation Grills

5" Aluminum Flex Duct
7
42 Apex CF