Electrical Line Hookup; Wiring Diagram - FireplaceXtrordinair 42 Apex Clean Face Installation Manual

38

Electrical Line Hookup

Make sure the household breaker serving the fireplace is shut off prior to working on any electrical lines.

The electrical line leading to the junction box inside the fireplace must be installed by a qualified
installer and must meet all local codes.

The appliance, when installed, must be electrically grounded in accordance with local codes or, in the
absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical
Code, CSA C22.1.

The electrical line must supply 120 Volts, 60 Hz, and 10 amps (2A for blower, 8A for optional igniter).

Route the electrical supply line through the junction box cover plate and attach to the hookup wires
(see illustration below).
NOTE: Details on the junction box are shown on the following page.

After all wiring is in place, replace the junction box cover and tighten the Romex clamps to secure the
wiring.

Wiring Diagram

Combustor Temp Display
(& GreenStart) Power Lead
Blower
Snap Disk
© Travis Industries
Installation
(for qualified installers only)
Fireplace Junction Box
Black
White
Green
Green
Black
White
Inside of Junction Box
8/24/2017 - 1450
Black
POWER IN
White
Green
Romex Clamps
Green
Black
White
Blower Rheostat
Junction Box
42 Apex CF