Configuring the IO Controller
7-4
Configuring the IO Controller
Opening the Master DTM
Configuration Interface
7-4-1
PLC Setup
Communication
92
After configuring all the slave DTMs, the CJ1W-PNT21 IO Controller DTM
must be configured. In order to open the IO Controller DTM Configuration
Interface do either one of the following.
•
Select the CJ1W-PNT21 IO Controller DTM in the Network view and
double-click the left mouse button.
•
Select the CJ1W-PNT21 IO Controller DTM in the Network view, and right-
click the mouse. From the context menu, select Configuration.
•
Select the CJ1W-PNT21 IO Controller DTM in the Network view, and from
the Device menu, select Configuration.
The DTM Configuration User Interface is shown below.
The communication path needs to be set to communicate with the IO
Controller. By pressing the Configure button. The CX-Server configuration
screen appears. Set the communication path and press the Test button to
check if the IO Controller can be reached. The Description and the Firmware
Version is displayed in the PROFINET IO Controller Unit Information.
Figure 7.8: PLC Setup
Section 7-4