Omron CJ1W-PNT21 Operation Manual page 72

Generic IO Device DTM
Modules sub-item
Defining the I/O
Configuration
58
The user can not set any items in this screen.
In the Modules sub-item the user needs to enter the actual module
configuration of the IO device. It must be exactly match the modules used by
the IO Device or the IO Device should accept the module configuration as its
actual configuration.
A list of available modules is read from the GSDML file of the IO Device.
The figure below shows an example of a module selection for a Omron GRT1-
PNT PROFINET IO device.
To define the I/O configuration the user must select each I/O module in the
same sequence as they are physically connected to the IO Device, while
observing the following prerequisites:
Figure 4.16: General information
Figure 4.17: Selecting modules
Section 4-4