Introduction
7-1
Introduction
Example
7-2
Setting up a Network
Start CX-ConfiguratorFDT
84
This section discusses the operational aspects of using the PROFINET IO
Controller Unit and the configuration software. The section has been setup, to
follow the general process flow of setting up and configuring a network,
downloading the configuration, and operating the PROFINET IO network.
To illustrate the explanations, examples are marked with the word Example in
the side line.
Setting up a network involves setting up a configuration in CX-
ConfiguratorFDT and downloading it to the PROFINET IO Controller Unit. To
start
CX-ConfiguratorFDT,
ConfiguratorFDT, from the Start Menu if the default program folder name is
used
CX-ConfiguratorFDT will now start, displaying the main window, as shown
below:
Before starting the assembly of the network in CX-ConfiguratorFDT, make the
following preparation steps.
select
Program,
Figure 7.1: CX-ConfiguratorFDT
Section 7-1
OMRON,
and
CX-