Omron CJ1W-PNT21 Operation Manual page 115

Configuring the IO Controller
Enable/Disable Auto
Addressing
The example shows that the sequence of IO Device No. is maintained, the
sequence of I/O modules selected is maintained and the I/O modules are
allocated to the lowest address of the area.
The Auto Addressing feature can be disabled in the CJ1W-PNT21 IO
Controller DTM. In order to do that, perform the following sequence.
1,2,3... 1 Open the CJ1W-PNT21 IO Controller DTM - Configuration User Interface.
2 Select the Configuration - IO Controller Setup sub item.
3 Enable/Disable Auto Addressing by selecting/de-selecting the Auto
Addressing enabled checkbox in the Auto-Addressing box.
4 When Auto Addressing is being enabled, a warning message is displayed,
informing the user of the effects of enabling Auto Addressing.
Initial I/O Configuration
The first Output modules
of IO Device #3 and #4
were moved to Output area 2.
Figure 7.15: Move IO Device
Section 7-4
101