Toyota Kluger 2004 Owner's Manual page 64

-Stowing the third seat seat
belt
To stow the third seat seat belt, insert
the tabs into the slot as shown above.
Make sure the tabs are securely locked
in the slot.
Seat belt must be stowed before you fold
the seatback. (See "-Folding down third
seat" on page 43 in this Section.)
NOTICE
Stow the seat belt of the third seat
when not in use.
-Front seat belt
pretensioners
The driver and front passenger's seat
belts pretensioner are designed to be
activated in response to a severe fron-
tal impact.
When the airbag sensor detects the shock
of a severe frontal impact, the front seat
belts are quickly drawn back in by the
retractors so that the belts snugly restrain
the front seat occupants.
The front seat belt pretensioners are acti-
vated even with no passenger in the front
seat.
The front seat belt pretensioners and SRS
airbags may not operate together in case
of collisions at a certain speeds and
angles.
V13400
This indicator comes on when the igni-
tion key is turned to the "ON" position.
It goes off after about 6 seconds. This
means the front seat belt pretensioners
are operating properly.
This warning light system monitors the
airbag sensor assembly, front airbag sen-
sors, side and curtain shield airbag sen-
sors, curtain shield airbag sensors, driv-
er's seat position sensor, driver's seat belt
buckle switch, front seat belt pretensioner
assemblies, inflators, warning light, inter-
connecting wiring and power sources. (For
details, see "Service reminder indicators
and warning buzzers" on page 115 in Sec-
tion 1-5.)
57