Toyota Kluger 2004 Owner's Manual page 22

Table of Contents

Advertisement

When all the side doors and back door
are unlocked simultaneously with a wire-
less remote control key, the center interior
light, personal lights and ignition switch
light come on for about 15 seconds before
fading out, even if the door is not opened.
(For details, see "Interior lights" on page
104, "Personal lights" on page 105 and
"Ignition switch light" on page 106 in Sec-
tion 1-4.)
You have 30 seconds to open a door after
using the wireless remote unlock feature.
If a door is not opened by then, all the
side doors and back door will be automati-
cally locked again. At this time, one beep
will be heard, and the turn signal lights
flash once.
The timing for the automatic door lock
function can be changed. For details, con-
tact your Toyota dealer.
If the "LOCK" or "UNLOCK" switch is kept
pressed in, the locking or unlocking opera-
tion is not repeated. Release the switch
and then push again.
The wireless door locking or unlocking
function can be erased. For details, con-
tact your Toyota dealer.
-Switching beep sound
You can switch the beep on and off. (The
beep is on initially and after battery re-
placement.)
To switch the beep on and off:
With the driver's door opened-
1. Insert the ignition key and remove it.
2. Within 5 seconds, insert the ignition
key again and turn it to the "ON" posi-
tion.
3. After
10
seconds,
push
the
same
"LOCK"
or
"UNLOCK"
switch
twice
within 10 seconds.
Two beep sounds inform you that the
program has been switched on or off.
If this procedure is not followed exactly,
the beep will not operate as expected.
Check the beep ON/OFF operation by
pushing the switch after you finish this
procedure. If the beep does not operate
as expected, repeat this procedure from
step 1.
-Replacing battery
For replacement, use a CR1616 lithium
battery or equivalent and a special screw-
driver.
&
CAUTION
Special care should be taken to pre-
vent small children from swallowing
the removed battery or components.
NOTICE
+
When replacing the battery, be care-
ful not to lose the components.
+Replace
only with
the
same or
equivalent type recommended by a
Toyota dealer.
+Dispose of used batteries according
to the local laws.
Replace the battery by following these
procedures:
15

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents