Toyota Kluger 2004 Owner's Manual page 33

SETTING THE SYSTEM
1. Turn the ignition key to the "LOCK"
position and remove it.
The indicator light will start flashing when
the key is removed from the ignition
switch. (See "Engine immobilizer system"
on page 12 in this Section for details.)
2. Have all passengers get out of the
vehicle.
3. Close and lock all the side doors, back
door and hood.
The indicator light will remain on when all
the side doors, back door and hood are
closed and locked.
26
The system will automatically be set after
30 seconds. When the system is set, the
indicator light will start flashing again.
4. After making sure the indicator light
starts flashing, you may leave the ve-
hicle.
Never leave anyone in the vehicle when
you set the system, because unlocking
from the inside will activate the system.
Canceling the system
The system will cancel within 30 seconds
before the system is set automatically un-
der any of the following conditions:
• Any of the side doors, back door or
hood is opened.
• Any of the side doors or back door is
unlocked.
o
The key is inserted into the ignition.
o
The battery terminal is reconnected.
If the tail lights come on for 2 seconds,
the theft deterrent system has been
alarmed. Check to see if there is any
abnormality with your vehicle.
WHEN THE SYSTEM IS SET
Activating the system
The system will sound the alarm under
the following conditions:
• If any of the side doors and back door
is unlocked or opened without the key
or wireless remote control key, or if the
hood is forcibly opened.
• If the battery terminal is disconnected
and then reconnected.
• If the ignition is hot-wired.
The indicator light will come on when the
system is activated.
If any of the side doors and back door is
unlocked without the key or wireless re-
mote control key and the key is not in the
ignition switch, all the side doors and
back door will be automatically locked
again.
After about 30 seconds, the alarm will
automatically stop and the indicator light
will start flashing again.
Reactivating the alarm
Once set, the system automatically resets
the alarm after the alarm stops.
The alarm will activate again under the
same circumstances described in
"Activating the system".