Planet VRT-401 User Manual page 79

Broadband vpn router

Table of Contents

Operations

Add

Edit

Move

En-

able/Disable

Copy

Delete

View Log

Adding a New Policy

1. To create a new VPN Policy, click the "Add" button on the VPN Policies screen.

This will start the VPN Wizard, as shown below.

If you prefer to use a single setup screen instead of a Wizard, click the Setup

Screen button. This is recommended for experienced users only.

To add a new policy, click the "Add" button. See the following

section for details.

To Edit or modify an existing policy, select it and click the "Edit"

button.

There are 2 ways to change the order of policies:

Use the up and down indicators on the right to move the

selected row. You must confirm your changes by clicking

"OK". If you change your mind before clicking "OK", click

"Cancel" to reverse your changes.

Click "Move" to directly specify a new location for the selected

policy.

Use this to toggle the On/Off state of the selected policy.

If you wish to create a policy which is similar to an existing policy,

select the policy and click the "Copy" button.

Remember that the new policy must have a different name, and

there can only be one active (enabled) policy for each remote VPN

endpoint.

To delete an exiting policy, select it and click the "Delete" button.

Clicking the "View Log" button will open a new window and display

the VPN log.

Figure 47: VPN Wizard - Start

VPN

Table of Contents