Chapter 8 Vpn; Overview - Planet VRT-401 User Manual

Chapter 8
VPN
This Chapter describes the VPN capabilities and configuration required
for common situations.

Overview

This section describes the VPN (Virtual Private Network) support provided by your
VRT-401.
A VPN (Virtual Private Network) provides a secure connection between 2 points, over
an insecure network - typically the Internet. This secure connection is called a VPN
Tunnel.
There are many standards and protocols for VPNs. The standard implemented in
VRT-401 is IPSec.
IPSec
IPSec is a near-ubiquitous VPN security standard, designed for use with TCP/IP
networks. It works at the packet level, and authenticates and encrypts all packets
traveling over the VPN Tunnel. Thus, it does not matter what applications are used on
your PC. Any application can use the VPN like any other network connection.
IPsec VPNs exchange information through logical connections called SAs (Security
Associations). An SA is simply a definition of the protocols, algorithms and keys used
between the two VPN devices (endpoints).
Each IPsec VPN has two SAs - one in each direction. If IKE (Internet Key Exchange) is
used to generate and exchange keys, there are also SA's for the IKE connection as
well as the IPsec connection.
There are two security modes possible with IPSec:
Transport Mode - the payload (data) part of the packet is encapsulated through
encryption but the IP header remains in the clear (unchanged).
VRT-401 does NOT support Transport Mode.
Tunnel Mode - everything is encapsulated, including the original IP header, and a
new IP header is generated. Only the new header in the clear (i.e. not protected)
This system provides enhanced security.
VRT-401 always uses Tunnel Mode.
IKE
IKE (Internet Key Exchange) is an optional, but widely used, component of IPsec. IKE
provides a method of negotiating and generating the keys and IDs required by IPSec.
If using IKE, only a single key is required to be provided during configuration. Also, IKE
supports using Certificates (provided by CAs - Certification Authorities) to authenti-
cate the identify of the remote user or gateway.
If IKE is NOT used, then all keys and IDs (SPIs) must be entered manually, and Cer-
tificates can NOT be used. This is called a "Manual Key Exchange".
When using IKE, there are 2 phases to establishing the VPN tunnel:
8
70