Simatic Move Instructions; Move Byte, Move Word, Move Double Word, Move Real - Siemens SIMATIC S7-200 System Manual

SIMATIC Instructions
9.9

SIMATIC Move Instructions

Move Byte, Move Word, Move Double Word, Move Real

L
MOV_B
A
EN
D
F
IN
B
D
MOV_W
EN
IN
MOV_DW
EN
IN
EN
IN
S
MOVB
T
MOVW
L
MOVD
MOVR
221 222 224
Move... Inputs/Outputs
IN
Byte Byte
OUT
IN
Word Word
OUT
IN
Double Word Double Word
OUT
IN
Real Real
OUT
9-102
The Move Byte instruction moves the input byte (IN) to
the output byte (OUT). The input byte is not altered by
ENO
the move.
OUT
The Move Word instruction moves the input word (IN) to
the output word (OUT). The input word is not altered by
the move.
ENO
The Move Double Word instruction moves the input
OUT
double word (IN) to the output double word (OUT). The
input double word is not altered by the move.
ENO
The Move Real instruction moves a 32-bit, real input
OUT double word (IN) to the output double word (OUT). The
input double word is not altered by the move.
MOV_R
ENO Error conditions that set ENO = 0: SM4.3 (run-time),
0006 (indirect address)
OUT
IN, OUT
IN, OUT
IN, OUT
IN, OUT
226
VB, IB, QB, MB, SB, SMB, LB, AC, Constant, *VD,
*AC, *LD
VB, IB, QB, MB, SB, SMB, LB, AC, *VD, *AC, *LD
VW, IW, QW, MW, SW, SMW, LW, T, C, AIW,
Constant, AC *VD, *AC, *LD
VW, T, C, IW, QW, SW, MW, SMW, LW, AC, AQW,
*VD, *AC, *LD
VD, ID, QD, MD, SD, SMD, LD, HC, &VB, &IB, &QB,
&MB, &SB, &T, &C, AC, Constant, *VD, *AC, *LD
VD, ID, QD, MD, SD, SMD, LD, AC, *VD, *AC, *LD
VD, ID, QD, MD, SD, SMD, LD, AC, Constant, *VD,
*AC, *LD
VD, ID, QD, MD, SD, SMD, LD, AC, *VD, *AC, *LD
Operands
S7-200 Programmable Controller System Manual
Data Types
BYTE
BYTE
WORD, INT
WORD, INT
DWORD, DINT
DWORD, DINT
REAL
REAL
A5E00066097-02