Set, Reset (N Bits) - Siemens SIMATIC S7-200 System Manual

Set, Reset (N Bits)

L
A
D
F
B
D
N
N
S
S
T
L
R
221 222 224
Inputs/Outputs
bit I, Q, M, SM, T, C, V, S, L
N VB, IB, QB, MB, SMB, SB, LB, AC, Constant, *VD, *AC, *LD
S7-200 Programmable Controller System Manual
A5E00066097-02
When the Set and Reset instructions are executed, the
bit
specified number of points (N) starting at the value
S
specified by the bit or OUT parameter are set (turned on)
N
or reset (turned off).
bit
R
The range of points that can be set or reset is 1 to 255.
N
When using the Reset instruction, if the bit is specified to
be either a T- or C-bit, then either the timer or counter bit
is reset and the timer/counter current value is cleared.
bit
S
Error conditions that set ENO = 0: SM4.3 (run-time),
0006 (indirect address), 0091 (operand out of range)
bit
R
bit, N
bit, N
226
Operands
SIMATIC Instructions
Data Types
BOOL
BYTE
9-7