Siemens SIMATIC S7-200 System Manual page 140

Setting Up Communications Hardware and Network Communications
In the Communications Setup dialog box, double-click the top icon on the
right-hand side. The Set the PG/PC Interface dialog box appears. See Figure 7-4.
Communications Links
Double click the icon representing the PLC
you
wish to communicate with.
Set the PG/PC Interface (V5.0)
Double click the module icon to change to
Access Path
communication parameters.
Double click the modem icon to setup the
modem parameters or dial to start modem
communications.
Communication Parameters
Remot
Local
Modul
Protoc
Trans
Mode
Figure 7-4
7-6
Communications Setup
Access Point of the Application:
Micro/WIN -->PC/PPI cable (PPI)
(Standard for Micro/WIN)
Interface Parameter Assignment Used:
PC/PPI cable (PPI)
CP5611(PROFIBUS)
CP5611(MPI)
CP5611(PPI)
CP5611(PROFIBUS)
PC internal (local)
PC/PPI cable (PPI)
(Assigning Parameters to a PC/PPI Cable
for a PPI Network)
Interfaces
Add/Remove
OK
Set the PG/PC Interface Dialog Box
PC/PPI
cable
Address: 0
Properties...
Copy...
Delete
Select...
Cancel Help
S7-200 Programmable Controller System Manual
A5E00066097-02