Ricoh M160 Service Manual page 784

Dedicated Transmission Parameters
No
Cable equalizer
Bit 7: 0, Bit 6: 0, Bit 5: 0 = None
Bit 7: 0, Bit 6: 0, Bit 5: 1 = Low
5-7
Bit 7: 0, Bit 6: 1, Bit 5: 0 = Medium
Bit 7: 0, Bit 6: 1, Bit 5: 1 = High
Bit 7: 1, Bit 6: 1, Bit 5: 1 = Disabled
No
Initial Tx modem rate
Bit3 Bit2
0 0
0 0
0-3 0 0
0 0
0 1
0 1
0 1
SM
Switch 01
FUNCTION
Switch 02
FUNCTION
Bit1 Bit0 Bps
0 0 Not used
0 1 2400
1 0 4800
1 1 7200
0 0 9600
0 1 12000
1 0 14400
COMMENTS
Use a higher setting if there is signal
loss at higher frequencies because
of the length of wire between the
modem and the telephone exchange
when calling the number stored in
this Quick/Speed Dial.
Also, try using the cable equalizer if
one or more of the following
symptoms occurs.
Communication error with error
codes such as 0-20, 0-23, etc.
Modem rate fallback occurs
frequently.

Do not use settings other
than listed on the left.
If the setting is "Disabled", the bit
switch setting is used.
COMMENTS
If training with a particular remote
terminal always takes too long, the
initial modem rate may be too high.
Reduce the initial Tx modem rate
using these bits.
For the settings 14.4 or kbps slower,
Switch 04 bit 4 must be changed to
0.

Do not use settings other
than listed on the left. If the
setting is "Disabled", the bit
switch setting is used.
128 M160/M161 Fax Option