Ricoh M160 Service Manual page 281

SC No. Level
SC818-00 D
SC No. Level
SC819-00 D
[0x5032]
[0x6261]
[0x696e]
[0x766d]
SM
Error Name/Error Condition/Major Cause/Solution
Watchdog timer error

The system program fell into a bus-hold state or an endless
loop of the program interruption occurred, causing other
process to stop.

System program defective

Controller board defective

Optional board defective

Turn the main power off/on.

Replace the controller board.
Error Name/Error Condition/Major Cause/Solution
Fatal kernel error
[XXXX]: Detailed error code
Due to a control error, a RAM overflow occurred during system
processing. One of the following messages was displayed on
the operation panel.

System program defective

Controller board defective

Optional board defective
Replace controller firmware
HAIC-P2 error
HAIC-P2 decompression error (An error occurred in the ASIC
compression/decompression module.)
HDD defective
6261 6420 6469 7200 00
gwinit process ending
x69742064 "init died"
VM is full
0x5f706167 "vm_pageout: VM is full"
6-37
"bad dir"
Service Call
M160/M161