Ricoh M160 Service Manual page 229


The progress bar appears on the operation panel.
9. The "Update Done" message appears on the operation panel after completing the
updating.
The message differs depending on the firmware that has been updated.
The name of the module in the bottom bar is the name of the last module that was updated
(only the name of the last module is shown, if several modules were been updated).
10. Turn the main power off and on. Then, select the items that you updated, and then
push the [Verify] button.
This is to check that the modules were updated correctly. Press in the SD card to release it.
Then remove it from the slot.
11. If you see "Verify Error" in the first bar on the screen, then you must do the procedure
again for the module shown in the bottom bar.

The "Verify" procedure is not necessary but it is strongly recommended.
12. After the firmware is correctly updated, turn the main power switch off, and then switch
the machine on for normal operation.
SM 5-9
Updating the Firmware
M160/M161