Configuring Hwtacacs Schemes - HP VSR1000 Security Configuration Manual

Step
3. Configure the service
consistency check mode for
SSH, FTP, and terminal
users.
Enabling SNMP notifications for RADIUS
When SNMP notifications are enabled for RADIUS, the SNMP agent supports the following notifications
generated by RADIUS:
RADIUS server unreachable notification—The RADIUS server cannot be reached. RADIUS
•
generates this notification if it does not receive a response to an accounting or authentication
request within the specified number of RADIUS request transmission attempts.
• RADIUS server reachable notification—The RADIUS server can be reached. RADIUS generates this
notification for a previously blocked RADIUS server after the quiet timer expires.
Excessive authentication failures notification—The number of authentication failures compared to
•
the total number of authentication attempts exceeds the specified threshold.
You can configure SNMP parameters to control the output of these SNMP notifications. For more
information, see Network Management and Monitoring Configuration Guide.
To enable SNMP notifications for RADIUS:
Step
1. Enter system view.
2. Enable SNMP notifications for
RADIUS.
Displaying and maintaining RADIUS
Execute display commands in any view and reset commands in user view.
Task
Display the RADIUS scheme
configuration.
Display RADIUS packet statistics.
Clear RADIUS statistics.

Configuring HWTACACS schemes

Configuration task list
Tasks at a glance
(Required.)
Command
attribute 15 check-mode { loose |
strict }
Creating an HWTACACS scheme
Command
system-view
snmp-agent trap enable radius
[ accounting-server-down |
authentication-error-threshold |
authentication-server-down |
accounting-server-up |
authentication-server-up ] *
Command
display radius scheme [ radius-scheme-name ]
display radius statistics
reset radius statistics
33
Remarks
The default check mode is strict.
Remarks
N/A
By default, all types of SNMP
notifications are enabled for
RADIUS.