Configuring Re-Dhcp Portal Authentication - HP VSR1000 Security Configuration Manual

IP address
Destination authenticate subnet:
IP address
A user can perform portal authentication by using the HP iNode client or through Web page. Before
passing the
http://192.168.0.1 1 1:8080/portal and all Web requests will be redirected to the authentication page.
After passing the authentication, the user can access Internet resources.
After the user passes authentication, you can use the following command to display information about
the portal user.
[Router] display portal user interface gigabitethernet 2/0
Total portal users: 1
Username: abc
Portal server: newpt
State: Online
Authorization ACL: None
MAC
0015-e9a6-7cfe

Configuring re-DHCP portal authentication

Network requirements
As shown in
an IP address through the DHCP server. A portal server serves as both a portal authentication server and
a portal Web server. A RADIUS server serves as the authentication/accounting server.
Configure re-DHCP portal authentication. Before passing the authentication, the host is assigned a
private IP address. After passing the authentication, the host gets a public IP address and can access
Internet resources.
Figure 28 Network diagram
authentication,
IP
2.2.2.2
Figure 28, the host is directly connected to the router (the access device). The host obtains
the user can access
VLAN Interface
-- GigabitEthernet2/0
87
Prefix length
Prefix length
only the authentication page