HP VSR1000 Security Configuration Manual page 111

Figure 32 Network diagram
Configuration prerequisites and guidelines
• Configure IP addresses for the router and servers as shown in
router, and servers can reach each other.
Configure the RADIUS server correctly to provide authentication and accounting functions.
•
• Make sure the IP address of the portal device added on the portal server is the IP address
(20.20.20.1) of the router's interface connecting the host. The IP address group associated with the
portal device is the subnet of the host (8.8.8.0/24).
Configuration procedure
Perform the following configurations on Router A.
1. Configure a RADIUS scheme:
# Create a RADIUS scheme named rs1 and enter its view.
<RouterA> system-view
[RouterA] radius scheme rs1
# Specify the primary authentication server and primary accounting server, and configure the keys
for communication with the servers.
[RouterA-radius-rs1] primary authentication 192.168.0.112
[RouterA-radius-rs1] primary accounting 192.168.0.112
[RouterA-radius-rs1] key authentication simple radius
[RouterA-radius-rs1] key accounting simple radius
[RouterA-radius-rs1] user-name-format without-domain
# Specify the security policy server.
[RouterA-radius-rs1] security-policy-server 192.168.0.113
[RouterA-radius-rs1] quit
# Enable RADIUS session control.
[RouterA] radius session-control enable
2. Configure an authentication domain:
# Create an ISP domain named dm1 and enter its view.
[RouterA] domain dm1
# Configure AAA methods for the ISP domain.
[RouterA-isp-dm1] authentication portal radius-scheme rs1
101
Figure 32 and make sure the host,