Xerox DocuColor 2240 Service Manual page 601

3. If a good Machine Settings floppy is available, exit, then reenter the PWS Tool. Select
Read from Floppy when starting the tool. If no floppy is available, or if the data on the
existing floppy is questionable, go to step 5.
4. Go to dC351 and select Restore Machine Settings. When restoration is complete, go to
step 7.
5. If a good Machine Settings floppy is not available, or if the data on the existing floppy is
questionable, go to dC351. In the Special Batch Write area, select the appropriate market
region, then press the Batch Write NVM button.
6. Using the resources gathered in step 1 of the removal procedure, reenter NVM data to
restore the machine configuration.
7. Ensure that the network information (IP address, etc.) is correct. Contact the customer's
system administrator to configure, if necessary.
8. Go to dC351 and select Save Machine Settings. Save the settings to floppy disk per the
procedure.
Initial issue
DC 3535/2240/1632
02/03
4-11
Repairs and Adjustments
REP 1.12