Rep 9.14 Mob Sensor Assembly; Rep 9.15 Ibt Belt Assembly - Xerox DocuColor 2240 Service Manual

REP 9.14 MOB Sensor Assembly

Parts List on PL 1.3
Removal
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
1. Open Front Cover.
2. Remove Waste Toner Cartridge (REP
3. Remove Fuser Cover (REP 14.8).
4. Remove Dispenser Cover (REP 9.6).
5. Remove Agitator Motor Assembly (REP
6. Remove MOB Sensor Assembly (Figure
a. Open harness clip and remove harness from clip.
b. Remove screw and remove Inner Cover.
c. Disconnect connectors (3)
d. Remove MOB Sensor Assembly Harnesses (violet) from additional harness clips
(not shown).
e. Remove MOB Sensor Screw and pull out to remove MOB Sensor Assembly. Xero-
graphic Release Lever must be down as shown.
Connectors (3)
MOB Sensor
Screw
Harness Clip
Screw
Inner
Cover
Figure 1 Removing MOB Sensor Assembly
Initial issue
DC 3535/2240/1632
WARNING
9.4).
9.13).
1).
Xerographic
Release
Lever

REP 9.15 IBT Belt Assembly

Parts List on PL 5.2
Removal
To avoid personal injury or shock, do not perform repair or adjustment activities with
the power switch on or electrical power applied to the machine.
1. Open Front Cover.
2. Release and move Xerographic Release Lever down.
3. Open Right Side Door.
4. Remove IBT Belt Assembly (Figure
a. Lift to release Slide Lock.
b. Pull out IBT Belt Assembly to remove it. Use handle to transport.
Handle
Slide
Lock
Figure 1 Removing IBT Belt Assembly
Replacement
Go to Detailed Maintenance Activities
02/03
4-83
WARNING
1).
and reset the HFSI counter for IBT Belt Assembly.
Repairs and Adjustments
REP 9.14, REP 9.15