Stopping The Sscnet Communication Driver - Mitsubishi Electric MELSEC System Q Installation Manual

4. SSCNET COMMUNICATION DRIVERS
4.5

Stopping the SSCNET Communication Driver

Double-click this icon.
To next page
When removing the interface board or interface card on Windows NT/98 from the
personal computer, you need to stop the SSCNET communication driver.
(When removing the interface card on Windows 98, use the plug and play function
of Windows. You need not perform the following operation.)
(1) For Windows NT
Click here.
1) Click [Start] on the taskbar and move the cursor to
[Settings].
Click [Control Panel].
2) The Control Panel window appears.
Double-click "Devices" from the Control Panel.
3) The "Devices" screen appears.
The SSCNET communication devices appear in the
device list.
Make sure that the following devices are displayed.
• SSCNET (CH. 0: Transient)
• SSCNET (CH. 0: Cyclic)
• SSCNET (CH. 1: Transient)*
• SSCNET (CH. 1: Cyclic)*
• SSCNET (Fast Fresh)
*1: For the interface card, CH. 1 does not appear.
*2: When you are using two or more interface
boards, transient and cyclic communication
devices for CH. 2 and later are displayed.
When there are four boards fitted, devices for
up to CH. 8 appear.
4) Choose SSCNET (Fast Fresh) and click [Startup...].
4 − 26