Updating Instructions And Procedures - Mitsubishi Electric MELSEC System Q Installation Manual

3. INSTALLATION AND UNINSTALLATION

3.7 Updating Instructions and Procedures

This section describes the instructions and operating procedures for updating
SW3RNC-GSVE to Ver. 00H.
The versions of the SW3RNC-GSVE Ver. 00H packages are indicated in Table
3.4.
Table 3.4 Package Definitions of SW3RNC-GSVE Ver. 00H
Type Version
SW3RN-GSV13P
SW3RN-GSV22P
SW3RN-GSV43P
SW3RN-GSV51P
SW3RN-CAMP
SW3RN-LADDERP
SW20RN-LADDERP
SW3RN-DOCPRNP
SW20RN-DOCPRNP
SW3RN-DOSCP
SW3RN-SNETP
(1) Updating performed when only SW3RNC-GSVE has been installed
• When performing updating in the personal computer where the SW3RNC-
GSVE Ver. 00F or earlier (the one in Table 3.4 or earlier) version has been
installed.
00E Transfer/assembly software
00E Automatic machine software
00D Machine tool peripheral software
00B Special-purpose robot software
00E Cam data creation software
00F Ladder editing software (For Office 97)
00B Ladder editing software (For Office 2000)
00H Document printing software (For Office 97)
00D Document printing software (For Office 2000)
00E Digital oscilloscope software
00J SSCNET communication system software
When updating, update one set of the above packages.
START
Uninstall all of the following packages.
SW3RN-GSV13P
SW3RN-GSV22P
SW3RN-GSV43P
SW3RN-GSV51P
SW3RN-CAMP
SW3RN-LADDERP(or SW20RN-LADDERP)
SW3RN-DOCPRNP(or SW20RN-DOCPRNP)
SW3RN-DOSCP
SW3RN-SNETP
Install all of the following packages.
SW3RN-GSV13P
SW3RN-GSV22P
SW3RN-GSV43P
SW3RN-GSV51P
SW3RN-CAMP
SW3RN-LADDERP(or SW20RN-LADDERP)
SW3RN-DOCPRNP(or SW20RN-DOCPRNP)
SW3RN-DOSCP
SW3RN-SNETP
Set up the SSCNET driver of SNETP.
(Refer to Chapter 4)
END
3 − 32
Product Name