When Using The A30Cd-Pcf Interface Card - Mitsubishi Electric MELSEC System Q Installation Manual

4. SSCNET COMMUNICATION DRIVERS
4.1.1

When using the A30CD-PCF interface card

For Windows NT
To next page
This section provides the SSCNET communication driver setup procedure for use
of the interface card.
For Windows 98
To 4)
1) The SSCNET Communication Driver Setup window
appears.
*You need not make the setting when you use
RS232C communication or do not use SSCNET
communication.
Click [Cancel] to exit from SSCNET Communication
Driver Setup.
<For Windows NT>
Choose "A30CD-PCF Card Type" and click [Detail].
<For Windows 98>
Choose "A30CD-PCF Card Type" and click [OK].
*Detail setting is not necessary for Windows 98.
2) Check and set the free areas of IRQ Level, Memory
Base Address and I/O Port Address.
Click [OK].
*For the way to check the free areas, refer to "4.2
How to Check the System Resources".
3) Click [OK].
4 − 2