Installation And Uninstallation; Installation - Mitsubishi Electric MELSEC System Q Installation Manual

3. INSTALLATION AND UNINSTALLATION

3. INSTALLATION AND UNINSTALLATION
3.1

Installation

This chapter provides how to install and uninstall GSV13P, GSV22P, GSV43P,
GSV51P, CAMP, LADDERP, DOSCP, SNETP and/or DOCPRNP.
This section gives the way to install and uninstall GSV13P, GSV22P, GSV43P,
GSV51P, CAMP, LADDERP, DOSCP, SNETP and/or DOCPRNP.
POINT
(1) Before starting installation, close all other applications running on
Windows NT/98/2000.
(2) If you install this software from the CD-ROM drive of the other Windows
95/98 personal computer via a network, "Setup.Exe not found." appears
and installation cannot be made.
After making setting to share the folder of this software to be installed in
the CD-ROM drive of the Windows 95/98 personal computer, assign it to
the network drive, execute "Setup.Exe", and install this software.
(3) If the installation of this software into the drive compressed in the drive
space has stopped at any point, increase the free space of the drive and
then press the [Retry] button to resume, or press the [Stop] button to stop
and change the drive to the one where the installation destination is not
compressed.
(4) In any of the following cases, always uninstall (refer to Section 3.5) and
reinstall the software.
• Installation failed midway
• Installation destination drive is to be changed
• Software is to be reinstalled
IMPORTANT
(1) When using SW3RN-GSV43P, you must add necessary data to the
"Config.nt" or "Config.sys" file.
For addition of necessary data, refer to "3.4.1 Precautions for Using
SW3RN-GSV43P".
(2) Different versions of SNETP and DOCPRNP cannot coexist and run.
Always reinstall them after uninstalling them.
(However, when Windows NT, Windows 98 and Windows 2000 are
installed in a single personal computer, the same versions of SNETP and
DOCPRNP can coexist in respective drives without any problem.)
(3) SW3RN-SNETP and SW6RN-SNETP (Ver. 00A) cannot coexist.
To make SW3RN-SNETP and SW6RN-SNETP coexist, install SW6RN-
SNETP Ver. 00B or later. (Refer to Section3.4.6 (2) for details.)
(4) For DOCPRNP and LADDERP, install the DOCPRNP or LADDERP
software package that meets the operating environment.
You cannot install and operate SW3RN-[ ][ ]P and SW20RN-[ ][ ]P
together.
Operating Environment
Office 97 (Word 97, Excel 97)
Office 2000(Word 2000, Excel 2000)
DOCPRNP
SW3RN-DOCPRNP
SW20RN-DOCPRNP
3 − 1
LADDERP
SW3RN-LADDERP
SW20RN-LADDERP