Mitsubishi Electric MELSEC System Q Installation Manual page 27

3. INSTALLATION AND UNINSTALLATION
From preceding page
<Screen 1>
<Screen 2>
<Screen 3>
18) When you installed GSV13P, GSV22P, GSV43P,
GSV51P or DOSCP, the left dialog box appears.
Click [OK].
18) The left screen appears on completion of
installation.
The screen displayed changes with the software
installed and their order of installation.
<For screen 1>
When using the software after completion of
installation, you need to restart Windows
NT/98/2000.
Check "Yes, I want to restart my computer now."
and click [Finish] to finish installation and restart
Windows NT/98/2000.
Check "No, I will restart my computer later." and
click [Finish] to finish installation without restarting
Windows NT/98/2000.
<For screen 2>
Check "I would like to view the README file." and
click [Finish] to display the REDME.TXT file and
finish installation.
Check "I would like to launch SW3RN-GSV22P."
and click [Finish] to finish installation and start
CAMP.
*The "I would like to launch SW3RN-GSV22P."
message changes with the software installed.
<For screen 3>
This screen appears on completion of SNETP
installation.
Click [Finish] to finish installation.
To make SSCNET communication in Windows
NT/98, you need to perform SSCNET
communication driver setup and communication
setting using GSV[ ][ ]P (Section 4.6).
For details, refer to Chapter 4.
3 − 7